Beater to Bowl Clearance
Your Stand Mixer is adjusted at the factory so the flat beater just clears the bottom of the bowl. If, for any reason, the flat beater hits the bottom of the bowl or is too far away from the bowl, you can correct clearance easily.
1.Turn speed control to “O”.
2.Unplug stand mixer or disconnect power.
3.Lift motor head.
4.Turn screw (A) SLIGHTLY counter
clockwise (left) to raise flat beater |
| |
or clockwise (right) to lower flat |
| |
beater. |
| |
5. Make adjustment with flat beater, |
| |
so it just clears surface of bowl. | A | |
If you over adjust the screw, the | ||
|
bowl lock lever may not lock into place.
NOTE: When properly adjusted, the flat beater will not strike on the bottom or side of the bowl. If the flat beater or the wire whip is so close that it strikes the bottom of the bowl, coating may wear off the beater or wires on whip may wear.
English
7
