Electronic Ignition System — initial lighting
Cooktop burners use electronic igniters in place of standing pilots. When the cooktop control knob is pushed in and turned to the “LITE” position, the system creates a spark to light the burner. This sparking continues until the control knob is turned to the desired setting.
OFF
L
I
T
E
15. Check operation of the cooktop burners. Push in and turn each control knob to “LITE” position. The flame should light within 4 seconds. Do Not leave the knob in the “LITE” position after burner lights.
If burners do not light properly, turn control knob to the “OFF” position. Check that burner cap is in the proper position. Check that power supply cord is plugged in and that circuit breaker or house fuse has not blown. Check that the shutoff valve is in the “ON” position. Check operation again. If a burner does not light at this point, contact your KitchenAid dealer for assistance.
16. Push in and turn each control knob to the “LO” (or simmer) setting. The “LO” setting of each burner has been factory set to the lowest setting possible to provide a stable flame. If it does not stay lit on the “LO” setting, check “LO” setting as follows:
a. Turn control to “LITE” until burner ignites.
b. Quickly turn knob down to LOWEST POSITION.
c. If burner goes out, readjust valve as follows:
Remove the burner control knob. Insert a
Installer checkoff list:
COOKTOP
✓Cooktop correctly positioned in countertop cutout.
✓Maintained specified distances to cabinet surfaces.
✓Cooktopto side. level – front to back – side
✓Burner caps positioned properly on sealed burner bases.
✓All packing material removed.
✓Backguard or island trim attached (see page 4).
ELECTRICAL
✓Polarized and grounded
GAS SUPPLY
✓Connection: 1/2" NPT with a minimum 5/8" (15.9 mm) diameter flex line.
✓The cooktop is connected only to type of gas for which it is certified for use.
If cooktop does not operate:
✓Check that the circuit breaker is not tripped or the house fuse blown.
✓Check that the power supply cord is plugged into the outlet.
✓Check that gas valves are turned to the “ON” position.
✓See Use and Care Guide for troubleshooting list.
If you need assistance:
The KitchenAid Consumer Assistance Center will answer any questions about operating or maintaining your cooktop not covered in the Installation Instructions. The KitchenAid Consumer Assistance Center is open 24 hours a day, 7 days a week. Just dial
When you call, you will need the cooktop model number and serial number. Both numbers can be found on the model/serial rating plate located on the bottom of the cooktop and are visible through the cutout in the
If you need service:
In the event that your KitchenAid appliance should need service, call the dealer from whom you purchased the appliance or a
You can also obtain the service company's name and number by dialing, free within the continental United States, the KitchenAid Consumer Assistance Center telephone number,
Maintain the quality built into your KitchenAid appliance — call a
Maintenance
If removing the cooktop is necessary for maintenance, shut off gas supply. Disconnect the gas and electric supply. After disconnecting the gas and electric supply, finish removing the cooktop. Generally, the cooktop does not need to be removed for servicing.
8
