Install the door handle (on some models)
IMPORTANT: Do not scratch the front panel during this procedure.
1.Remove the door handle and hardware bag containing the setscrews and Allen wrench from the cardboard box.
2.Start set screws in handle.
3.Place handle on mounting studs with the set screws facing down.
4.Push the door handle tightly against the door. Insert the short end of the Allen wrench into the setscrews. Tighten the setscrews 1/4 turn past snug. Retain Allen wrench with Installation Instructions.
mounting 
stud
handle
setscrew (in bottom of handle)
Allen wrench
Pro Line® Series
1.Remove the Pro Line® Series handle and two screws from handle package.
2.Make sure plastic spacers are still attached to the door.
3.Attach the handle to the
plastic spacers |
5.Gently set panel aside.
NOTE: Some models have 4 screws per side.
screws
| inner |
|
screws | door | do not remove screw. |
| panel |
6.Lay the
7.Place the inner panel on the back of the full front panel as shown and attach, using the four
4 screws
full front panel
inner door panel | top of panel |
8.Attach the
9.Reinstall the two uppermost screws into the inner panel, do not tighten completely. This will hold the full front panel in place on the door frame.
2 screws
Install door panel
NOTE: Features on your dishwasher may differ from model shown.
For top vented models with a
(Pro Line® series)
top vent
10.Install the two
11.Align the top edge of the full front panel with the top edge of the console and secure corner screws.
12.Tighten the two screws installed in Step 9.
13.Reinstall and tighten the remaining screws in the inner panel.
1.Remove the carton containing the
2.Remove the handle package from the front of the shipping base.
3.Remove the inner panel from the door.
4.With a TORX® screwdriver, remove three screws from both sides of the door. Hold the inner panel up while removing the screws.
2 screws 
align top edges
11
