10
18. Line up the bracket holes with the pin holes and replace each
pin so that the pin line is vertical.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Check that the dishwasher is level, securely fastened to the
cabinetry and opens and closes freely with no resistance from
the cabinetry.
3. Check that the inlet hose to valve connection is tightened an
additional half turn after seal contact.
4. Check that any knockouts of plugs in the drain connection
have been drilled out and drain connection has been made.
5. Turn on the power and water supply. The dishwasher should
beep and the controls should light up.
6. Open the drawer and check the operation of the wash
program control panel.
7. Check that the spray arm is in place and rotates freely.
8. On the wash program control panel, select rinse and close the
drawer. Start the program by pressing the Start/Resume
button.
9. After the rinse program has finished, be sure the dishwasher
has run and drained correctly.
10. Check the water supply and drainage connection for leakage.
11. Check that you have all of your tools.
12.Dispose of/recycle all packaging materials.
13.Read “Dishwasher Use” in the Drawer Dishwasher Use and
Care Guide.
If dishwasher does not operate, check the following:
■Household fuse is intact and tight; or circuit breaker has not
tripped.
■Electrical supply is connected.
■See “Troubleshooting” in your Use and Care Guide.
pin
14. Align the centerline marked on the custom door panel with the
diamond shape and notch in the metal plate to center the
metal plate horizontally. Align the horizontal line with the top
of the metal plate.
15. Using the screws provided, fasten the metal plate to the door
panel through the 3 inner holes (per side).
16. Connect the medallion connector to the dishwasher
connector.
17. Slide the metal plate tabs into the notches and slots on the
dishwasher and gently pull up to lock in place.
centerline
horizontal line
top of plate
3 inner holes
end of medallion
connector
door panel