KitchenAid 9763388 Make Electrical Connection, Hood size 36 91.4 cm 14 ³⁄₁₆ 36.0 cm 48 121.9 cm

4.■ If using the rear electrical knockout, drill a 1¹⁄₄" (3.0 cm) dia. hole through the wall at the location shown.

hood support		centerline
(front view)					A
		of hood
				2"		(5.1 cm)
	Hood size			A
	36" (91.4 cm)		14³⁄₁₆" (36.0 cm)
	48" (121.9 cm)		20¹⁄₄" (51.4 cm)

■If using the top electrical knockout, drill a 1¹⁄₄" (3.0 cm)

hood support	2" (5.1 cm)
(top view)

right rear hood mounting hole

1¹⁄₂"

(3.8 cm)

dia. hole through the hood support at the location shown.

5.Remove the filters. Use two hands to remove filter. Push tab

back to release the locking pin, pull down and forward. Set filter aside. Repeat with other filter(s).

6.Remove the wiring box cover located behind the right hand filter.

7.Install UL- or CSA-listed strain relief in hood liner so that

screws can be tightened.

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all parts and panels before operating.

Failure to do so can result in death or electrical shock.

Make Electrical Connection

1.Disconnect power.

2.Run power supply cable to the hood electrical hole according the National Electrical Code or CSA Standards and local codes and ordinances. There must be enough power supply cable from the fused disconnect (or circuit breaker) box to make the connection in the hood’s electrical wiring box.

WARNING

Excessive Weight Hazard

Use two or more people to move and install range hood. Failure to do so can result in back or other injury.

3.Remove the four mounting screws from the parts bag. It is recommended they be placed by the holes in the hood liner support for quick access.

4.While feeding the wiring through the strain relief, lift the hood

8