liner into place.
5.Insert the screws through the support and thread into the
WARNING
Electrical Shock Hazard
Electrically ground the blower.
Connect ground wire to green ground screw in wiring box.
Failure to do so can result in death or electrical shock.
hood liner holes. Tighten screws securely.
A | B |
| C |
A. Ground screw connector
B. Ground wire
C. Power supply cable
6.Use
7.Use
8.Connect green or bare wire to the ground screw connector.
9.Tighten strain relief securely.
10.Replace wiring box cover. Tighten screw securely.
11.Reconnect power.
Complete Installation
1.Connect vent system to hood liner.
2.Seal joints with duct tape.
Check Operation
A
B CD
A.Controls
B.Light switch
C.Blower switch
D.Blower speed control switch
1.Check operation of the range hood by turning the power on.
2.Move the light switch to the “1” position. The light should turn on.
3.Move the light switch to the “0” position. The light should turn off.
4.Move the blower switch to the “1” position. The blower should turn on.
5.Move the blower speed control switch to vary the blower speed from low (left) to high (high).
6.Move the blower switch to the “0” position. The blower should turn off.
7.If range hood does not operate, check that the circuit breaker has not been tripped or the house fuse blown. Disconnect power supply and check that the wiring is correct.
8.Reinstall filters. Place back edge of filter into channel at rear of hood liner and push filter up while pushing tab back. When filter is in place, release tab. Locking pin will hold filter in place.
9.Repeat for other filter(s).
10.Install hood enclosure.
9
