10
13. Place the vent hood on its back side on a protected surface.
a) Slide the screen forward.
b) Pull the tabs to remove the filters.
c) Remove the terminal box cover.
d) Close the screen.
e) Slide the mounting brackets to the top position.
NOTE: For some installations using the reci rculating kit, it
may be easier to attach the vent system to the hood before
lifting the hood into its final position. Seal the connect ion with
clamps.
Install Range Hood
1. Lift the vent hood into its final position and feed the electrical
wire through the wiring opening in the range hood. The
mounting brackets should overlap the cabinet bottom or
wood filler strips. Center the range hood.
2. Check that the front panel is parallel with the cabinet front
when the screen is pushed in. Slide the screen forward.
Tighten the mounting bracket screws so that the vent hood is
secured to the cabinet.
3. Align the hood front panel with the cabinet. Slide the screen
forward. Locate the 2 screws on each side and turn them
counterclockwise to loosen the screws. Adjust the front of the
vent vertically, ³⁄₈" (9.5 mm) up or down, or horizontally,
³⁄₄" (19 mm) front to back, until the front is flush with th e
cabinet. Tighten the screws. If it is necessary to adjust the
given dimensions, lower and add or remove the filler strips or
redrill mounting holes.
Electrical Connection
1. Disconnect power.
2. Connect the white wire of the power supply cable to the white
wire in the hood with a twist-on connector.
A. Terminal box cover
A.Mounting bracket
B.Cabinet bottom
C.Optional wood filler strip
D.Vent hood
A
A
B
C
D
A.Mounting bracket screw
B.Flat-blade screwdriver
A.Phillips screwdriver
B.Adjustment screws
A
B
A
B
WARNING