KitchenAid 9763393A RANGE HOOD USE

12

Optional Front Trim Kits

Front trim kits for matching the front panel to your range or

cooktop color are available from your dealer.

For ordering information see the “Assistance or Service” section.

For 30" (76.2 cm) model series

KWVU205:

Part No. 4360201 (white)

Part No. 4360203 (black)

Part No. 4392855 (biscuit)

For 36" (91.4 cm) model series

KWVU265:

Part No. 4360202 (white)

Part No. 4360204 (black)

Part No. 4392856 (biscuit)

For 30" (76.2 cm) model series

GZ7730:

Part No. 4396067 (white)

Part No. 4396066 (black)

Part No. 8171368 (biscuit)

IH5302:

Part No. 4396844 (white)

For 36" (91.4 cm) model series

GZ7736:

Part No. 4396069 (white)

Part No. 4396068 (black)

Part No. 8171369 (biscuit)

Install Front Trim Kit

1. Pull out on the range hood for easier access to the screws.

2. Remove the 3 mounting screws directly behind the front

panel, and remove the front panel from the range hood.

3. Remove existing trim piece and insert new trim piece.

4. Reattach front panel using the 3 mounting screws.

5. Push the range hood back in.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before

cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

KWVU Model Series

Operating the Fan

1. Slide the shelf forward.

2. Press the speed buttons for the desired speed.

Speed may be increased, decreased, or turned off at anytime

during the vent hood operation. The indicator light next to th e

speed button selected should be on when the fan is running.

3. Press the 0 button or close the shelf to shut off the fan.

The fan will shut off when the shelf is about 2" (5.1 cm) from

the closed position. When the shelf is opened the fan will

operate at the last setting.

Operating the Light

1. Open the shelf about 1" (2.5 cm).

2. Press the light button.

The light will be on each time the shelf is opened. The light

can be used for a night light by opening the shelf about

1" (2.5 cm).

3. Press the light button to turn off the light.

Another option for turning off the vent hood light is to close

the shelf.

A.Three mounting screws

A

A.Light button

B.Speed buttons

AB

Contents

Main TABLE OF CONTENTS TABLE DES MATIRES RANGE HOOD SAFETY Your safety and the safety of others are very important. DANGER IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS INSTALLATION REQUIREMENTS Toolsand Parts Too ls n ee de d Parts supplied Parts needed Product Dimensions Installation Clearances VentingRequirements Cold weather installations Makeup air Venting Methods Calculate Vent System Length Example vent system 3" x 10" (8.3 cm x 25 cm) Recommended Standard Fittings INSTALLATION INSTRUCTIONS Prepare Location Preparation Venting Outside Through the Roof Venting Outside Through the Wall Venting Inside Through the Soffit/Cabinet Page Install Range Hood Electrical Connection WARNING Connect the Vent System Vented installations: Recirculation installations: A Optional Front Trim Kits RANGE HOOD USE KWVU Model Series Operating the Fan Operating the Light GZ and IH Model Series RANGE HOOD CARE Cleaning Exterior surfaces: Metal Filters: Replacing the Bulb WIRING DIAGRAMS KWVU Model Series GZ and IH Model Series ASSISTANCE OR SERVICE If you need replacement parts In the U.S.A. Our consultants provide assistance with: For further assistance WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY KITCHENAIDVENTILATION WARRANTY SCURIT DE LA HOTTE DASPIRATION Votre scurit et celle des autres est trs importante. DANGER AVERTISSEMENT IMPORTANTES INSTRUCTIONS DE SCURIT CONSERVEZ CES INSTRUCTIONS AVERTISSEMENT : AVERTISSEMENT : AVERTISSEMENT : EXIGENCES DINSTALLATION Outillage et pices Outillage ncessaire Pices fournies Pices ncessaires Dimensions du produit Dgagements de sparation respecter Exigences concernant lvacuation Mthodes d'vacuation Calcul de la longueur effective du circuit d'vacuation Raccords standard recommands Exemple de systme de dcharge 3" x 10" (8,3 cm x 25 cm) Conduit pour dcharge l'intrieur travers le soffite/ placard Spcifications lectriques Pour les modles Srie GZ ou IH : Pour les modles Srie KWVU : ABC INSTRUCTIONS D'INSTALLATION Prparationde l'emplacement Prparation Dcharge l'extrieur, travers le toit Dcharge travers le mur Recyclage travers le soffite/placard Page Installation de la hotte de cuisinire Raccordement lectrique Raccordement du circuit d'vacuation A Installations avec dcharge l'extrieur (recyclage) : AVERTISSEMENT Ensembles de garniture (option) Pour les modles de 30" (76,2 cm) Pour les modles de 36" (91,4 cm) Sries KWVU265 : Pour les modles de 30" (76,2 cm) UTILISATION DE LA HOTTE DE CUISINIRE Modles Sries KWVU Commande du ventilateur Commande d'clairage Modles Sries GZ et IH ENTRETIEN DE LA HOTTE DE CUISINIRE Nettoyage Surfaces extrieures : Filtres mtalliques : Remplacement de la lampe SCHMA DE CBLAGE Modles Sries KWVU Vi u Modles Sries GZ et IH ASSISTANCE OU SERVICE N TRANSFORMATEUR/BALLAST BL N GARANTIE DES GROS APPAREILS MNAGERS WHIRLPOOL CORPORATION GARANTIE DU SYSTME DE VENTILATION KITCHENAID