BUILT-IN OVEN SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean:
DANGER
WARNING
You can be killed or seriously injured if you don't immediately follow instructions.
You can be killed or seriously injured if you don't follow instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed.
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed
■Adjustable wrench or ⁵⁄₈" wrench
■Phillips screwdriver
■
■Measuring tape
■Hand or electric drill (for wall cabinet installations)
■1" (25 mm) drill bit (for wall cabinet installations)
■Level
■Copper tubing cutter
Parts supplied (1 box, 3 plastic bags)
■One - ³⁄₈" stem to ¹⁄₄" quick connect
■Two - ³⁄₈" elbow to ¹⁄₄" quick connects
■Water filter
■
■
■Bottom vent (supplied on some models)
■
Parts needed
■UL listed or CSA approved conduit connector
■UL listed wire connectors
■Tubing staples/retainers
■¼" O.D. copper tubing (to make water connection)
NOTE: Due to temperatures around oven, copper tubing is required.
■Water connection device (to connect ¼" O.D. copper tubing to water source). Check local codes for type of connection required.
■¼" to ¼" water supply union (between copper tubing from the filter and copper tubing attached to oven).
Check local codes. Check existing electrical supply. See “Electrical Requirements.”
It is recommended that all electrical connections be made by a licensed, qualified electrical installer.
Built-In Microwave/Oven Combination
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
■Cabinet opening dimensions that are shown must be used. Given dimensions provide minimum clearance with oven.
■Recessed installation area must provide complete enclosure around the recessed portion of the oven.
■Grounded electrical supply is required. See “Electrical Requirements” section.
■Electrical supply junction box should be located 3" (7.6 cm) maximum below the support surface when the oven is installed in a wall cabinet. A 1" (2.5 cm) minimum diameter hole should have been drilled in the right rear or left rear corner of the support surface to pass the appliance cable through to the junction box.
■Oven support surface must be solid, level and flush with bottom of cabinet cutout. Floor must be able to support a total weight (microwave and
2
