Replace Door and Hinges |
| Replace Drawer |
NOTE: When reversing panel series door, use alternate top hinge shipped with refrigerator.
1.Replace the parts for the bottom hinge as shown in Bottom Hinge graphic. Tighten screws. Replace the refrigerator door.
NOTE: Provide additional support for the refrigerator door while the hinges are being moved. Do not depend on the door gasket magnets to hold the door in place while you are working.
2.Assemble the parts for the top hinge as shown in the Top Hinge Graphic. Do not tighten screws completely.
3.Line up the door so that the bottom of the refrigerator door aligns evenly with the top of the freezer drawer. Tighten all screws.
Freezer Drawer
Graphics are included later in this section.
Remove Drawer
IMPORTANT: Two people may be required to complete this procedure.
1.Open the freezer drawer to full extension.
2.Remove all articles from baskets.
3.Pull the upper wire basket out to full extension and lift out to remove.
4.Lift lower basket straight up and out to remove.
5.Remove the basket cradles from the drawer rails. Push the snap attachments inward away from the drawer rails to unlatch the basket cradles. Lift the basket cradles off of the drawer rails.
A
B |
IMPORTANT: Two people may be required to complete this procedure.
1.Pull both drawer rails out to full extension.
2.Locate the notches on the inside of each drawer rail. See Graphic
3.While supporting the drawer front, hook the drawer supports into the notches on the inside of the drawer rails. Lower the drawer front into its final position. See Graphic
4.Place the basket cradles back on the drawer rails. Align the snap attachments with the slots on the drawer rails, and press each snap toward the rail until it clicks.
5.With drawer rails pulled out to full extension, set the lower basket straight down into the basket cradles.
6.Slide the upper basket into the molded drawer rail. Make sure the rear of the basket hooks behind the drawer rail stop.
Final Steps
1.Check all holes to make sure that hole plugs and screws are in place. Reinstall top hinge cover. See Top Hinge Graphic.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
2.Plug into a grounded 3 prong outlet.
3.Return all removable door parts to doors and food to refrigerator.
A. Cradle snap attachment
B. Basket cradle
6.Lift the top of the freezer drawer front to disengage drawer rail hooks from drawer rails. Lift drawer out.
9
