KitchenAid KCM1402, KCM1203 Plug into a grounded 3-prong outlet, To Set the Time-of-Day Clock

4.Place the filter cartridge in the well at the bottom of the water tank. Push the cartridge slightly to make sure it fits snugly.

5.Every time you install a new filter, run the coffee maker through a complete brewing cycle without coffee. Use a full carafe

of clean, cool water. See “Coffee Maker Care” for information on when to change the water filter.

To Set the Time-of-Day Clock for the First Time or After Power Outage

1.Plug into a grounded 3-prong outlet.

2.When the coffee maker is first plugged in or when power is restored after an interruption, the brew timer display will initially show 12:00 AM, with the hours section flashing “12”. The Clock indicator will flash while the time is being set.

3.Press the “+” (plus) or “-” (minus) buttons to increase or decrease the hours.

4.Press the SET button. The minutes digits will flash for the minutes adjustment.

5.Press the “+” (plus) or “-” (minus) buttons to increase or decrease the minutes.

6.Press the SET button again The AM or PM indicator will flash for the AM/PM adjustment.

7.Press the “+” (plus) or “-” (minus) buttons to select AM or PM.

8.Press SET button to choose the selected time. Two short beeps will sound indicating programming is complete.

To Set the Time-of-Day Clock

When the coffee maker is first plugged in, or after a power interruption of more than one minute, the coffee maker will power up in the clock setting mode. In this case, follow the previous directions “To Set the Time-of-Day Clock for the First Time or After Power Outage”. If adjusting the time of the clock after initial set up, follow the complete instructions below.

1.For glass carafe models, press the MENU button 6 times to enter the Time/Clock Setting mode. The Clock indicator will flash while the time is being set.

NOTE: For thermal carafe models, press the MENU button 5 times to enter the Time/Clock Setting mode.

2.Press the “+” (plus) or “-” (minus) buttons to increase or decrease the hours.

3.Press the SET button. The minutes digits will flash for the minutes adjustment.

4.Press the “+” (plus) or “-” (minus) buttons to increase or decrease the minutes.

5.Press the SET button again The AM or PM indicator will flash for the AM/PM adjustment.

6.Press the “+” (plus) or “-” (minus) buttons to select AM or PM.

7.Press SET button to choose the selected time. Two short beeps will sound indicating programming is complete.

9