1. Removing the packaging and controls:
• After unpacking, make sure that the dishwasher
is undamaged and that the door closes correctly.
If in doubt, contact a qualified technician or your
local retailer.
• Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children,
as they are potentially dangerous.
• This dishwasher has been factory tested to
ensure it functions correctly.
Such testing may leave slight water marks that
will disappear with the first wash.
2. Water and electrical connections:
All water and electrical connections must be
carried out by a qualified technician in
compliance with the manufacturer's instructions
(refer to the enclosed installation booklet) and
current local safety regulations.
This appliance must only be used in the
household for the prescribed uses.
Do not use this dishwasher if it has been
damaged in transit. Consult your local retailer
or our Customer Care Centre.
(Refer to the separate installation instructions
booklet)
3. Water inlet and drain:
• Observe any special regulations issued by your
local Water Board.
Water supply pressure: 0,3 - 1,0 MPa.
• Make sure the inlet and drain hoses are kink-
free and are not crushed.
• If the hose length is not sufficient, please contact
your local dealer or our Customer Care Centre.
• The inlet hose must be securely clamped to the
water tap to prevent leaks.
• The inlet water temperature varies according to
the model installed. Inlet hose marked “25°C
Max”: maximum temperature 25°C.
All other models: maximum temperature 60°C.
• When installing the appliance, make sure the
drain water discharges correctly (if necessary,
remove drain filter).
• After installation check leak tightness all water
connections. Leaky connection can damage your
home caused by flooding.
4. Electrical connection:
• Closely adhere to local Electricity Board
regulations.
• Voltage information is shown on the rating plate
mounted inside the door on the right hand side.
• The appliance must be grounded as prescribed
by law.
• Do not use extension leads or multiple
adapters.
• Before carrying out maintenance, disconnect
the mains plug.
• If necessary, the power cable may be replaced
with one the same obtained from our After-
Sales Service via our Customer Care Centre.
The power cable must only be replaced by a
qualified technician.
EC Declaration of conformity
This appliance has been designed, constructed
and distributed in compliance with the safety
requirements of these EC Directives:
• the safety objectives of Low Voltage Directive
2006/95/EC (replacing 73/23/EEC and
subsequent amendments);
• 89/336/EEC
• 93/68/EEC
Load capacity:
5 place settings according EN 50242.
Before using your dishwasher
5
501970902004_GB 26-07-2007 9:14 Pagina 5