30" (76.2 cm) Freestanding and Slide-In Dual Fuel Range
PRODUCT MODEL NUMBERS
KDRS807S KDRS807X KDSS907S KDSS907X
GAS SUPPLY REQUIREMENTS
Natural gas:
This range is
●This range is factory set for use with Natural gas. See “Gas Conversions” section. The model/serial rating plate located behind the storage drawer on the
LP gas conversion:
Conversion must be done by a qualified service technician.
Gas Supply Line
●Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be ¹⁄₂" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials used in the system.
NOTE:
If local codes permit, a new CSA
Must include a shutoff valve:
The supply line must be equipped with a manual shutoff valve. This valve should be located in the same room but external to the range opening, such as an adjacent cabinet. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the range.
†®TEFLON is a registered trademark of E.I. Du Pont Nemours and Company.
ELECTRICAL REQUIREMENTS
This range is manufactured with the neutral terminal connected to the cabinet. Use a
PRODUCT DIMENSIONS
Freestanding Range
B
A
C*
D*
E
F**
A. 5³⁄₄" (14.6 cm) | E. Model/serial number plate | |
B. 30" (76.2 cm) | (located on the | |
C. 41³⁄₄" (106.0 cm) overall height | side oven door trim) | |
F. 27¹⁄₄" (69.2 cm) max. from | ||
with leveling legs screwed all | ||
the way in.* | handle to standoff at back | |
D. 36" (91.4 cm) cooktop trim | of range** | |
height with leveling legs |
| |
screwed all the way in* |
|
*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.
**When installed in a 24" (61.0 cm) base cabinet with 25"
(63.5 cm) countertop; front of oven door protrudes 1" (2.5 cm) beyond 24" (61.0 cm) base cabinet.
neutral, use a
Range Rating* |
| Specified Rating of Power Supply |
|
| Cord Kit and Circuit Protection |
120/240 Volts | 120/208 Volts | Amps |
8.8 - 16.5 KW | 7.8 - 12.5 KW | 40 or 50** |
16.6 - 22.5 KW | 12.6 - 18.5 KW | 50 |
|
|
|
** The NEC calculated load is less than the total connected load listed on the model/serial rating plate.
**If connecting to a
●A circuit breaker is recommended.
*Range can be raised approximately 1" (2.5 cm) by adjusting the leveling legs.
**When installed in a 24" (61 cm) base cabinet with 25" (63.5 cm) countertop; front of oven door protrudes 1³⁄₄" (4.4 cm)
(2³⁄₁₆" [5.5 cm] on models KDRS807XSP and KDSS907XSP) beyond 24" (61.0 cm) base cabinet.
Slide-in Range
A
F
E**
A. 30⁹⁄₁₆" (77.6 cm)
B. 35⁵⁄₈" (90.5 cm) height to underside of cooktop edge with leveling legs screwed all the way in*
C. Model/serial number plate (located on the
B*
C
D
D30" (76.2 cm)
E.27¼" (69.2 cm)
(27¹¹⁄₁₆" [70.3 cm] on models KDRS807XSP and KDSS907XSP) from handle to standoff at back of range**
F.23" (58.4 cm) countertop
notch to rear of cooktop Page 1 of 2
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation | Ref. W10526084A |
Instructions packed with product. Specifications subject to change without notice. | 5/6/13 |