17

To Replace:

Before replacing, make sure the oven is off and cool.
1. Disconnect power.
2. Remove glass light cover by grasping the front edge and
pulling away from oven.
3. Remove bulb from socket.
4. Replace bulb, using tissue or wearing cotton gloves to handle
bulb. Do not touch bulb with bare fingers.
5. Replace bulb cover by snapping back into wall.
6. Reconnect power.

OvenDoor

For normal range use, it is not suggested to remove the oven
door. However, if removal is necessary, make sure the oven is off
and cool. Then, follow these instructions. The oven door is heavy.

To Remove:

1. Open oven door all the way.
2. Flip up the hinge latch on each side.
3. Close the oven door as far as it will shut.
4. Lift the oven door while holding both sides.
Continue to push the oven door closed and pull it away from
the oven door frame.

To Replace:

1. Insert both hanger arms into the door.
2. Open the oven door.
You should hear a “click” as the door is set into place.
3. Move the hinge levers back to the locked position. Check
that the door is free to open and close. If it is not, repeat the
removal and installation procedures.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.

Nothing will operate

■Has a household fuse blown, or has a circuit breaker
tripped?
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
■Is the appliance wired properly?
See Installation Instructions.

Oven will not operate

■Is the electronic oven control set correctly?
See “Electronic Oven Control” section.
■Has a delay start been set?
See “Timed Cooking” section.
■Is the Control Lock set?
See “Control Lock” section.
■Is the Sabbath Mode set?
See “Sabbath Mode” section.

Oven temperature too high or too low

■Does the oven temperature calibration need adjustment?
See “Oven Temperature Control” section.

Display shows messages

■Is the display showing “PF”, “PF id=27” or “PF id=30”?
There has been a power failure. Clear the display. See
“Display” section. On some models, reset the clock, if
needed. See “Clock” section.
■Is the display showing a letter followed by a number?
Clear the display. See “Display” section. If it reappears, call
for service. See “Assistance or Service” section.

Self-Cleaning cycle will not operate

■Is the oven door open?
Close the oven door all the way.
■Has the function been entered?
See “Self-Cleaning Cycle” section.