Now start...
1.Put a thick protective covering over cooktop,
If installing over a freestanding range, disconnect and move the range to provide easier access to the upper cabinet and rear wall.
Slide range onto cardboard or hardboard before moving to prevent damaging floor covering.
2.Place hood on a protective cover with filters facing down.
3.Determine which venting method (roof, wall or
•The hood is
•For
seal plate
vent connection
If venting through the wall, remove seal plate from back of hood and vent connector from top of hood. Reinstall vent connector onback of hood and seal plate on top of hood.
top
knockout
do not use
centerlines
5.Mark centerlines on rear wall and upper cabinet bottom.
For
template |
6.Align centerlines of template with centerlines marked on rear wall and upper cabinet bottom. Tape template in place. Mark location of the four holes used to secure hood to upper cabinet.
7.Depending on your installation, mark location of the wiring hole or vent cutout in upper cabinet or back wall needed as shown on template.
8.Remove template.
9.Drill four 3/16" (5.0 mm) diameter holes through upper cabinet for the hood mounting screws.
10.Drill the
11.Make the vent cutout for
12.Turn the hood over so
13.Rotate deflector away from filters. Pull grease filter handles toward back of hood to release locking tabs. Lift filters up, remove from hood and set aside.
screw locations
screw
14.Remove 2 screws from light panel tabs. On light panel surface directly behind tabs, push toward back of the hood to move tabs out through the slots. Remove panel and set aside with screws.
remove screws
wiring
box cover
15.Remove 2 screws from wiring box cover located in the right hand rear corner and remove cover. Attach the U.L.- or CSA-
back knockout
these
knockouts
filters face up.
listed strain relief to the hood wiring hole being used.
4.Remove knockout from the wiring opening (top or back) to be used.
4
16.Turn hood over so filters face down.
