3-5
Error
Code
Error Solution
F0 An internal error
was detected.
Disconnect power. Wait
5seconds before reconnecting
power. If the symbol appears
again, call customer service.
F2 The surface
cooking area is
too hot and has
turned off.
Remove the pans from the
surface cooking area. “F2” will
disappear when the surface
cooking area has cooled down. If
you turn the surface cooking area
back on and “F2” reappears, the
cooktop is still too hot. Turn off
the surface cooking area and
allow it to cool.
F4 The pot or pan is
too close to the
control panel.
Make sure the pot or pan is
centered on the surface cooking
area and nothing hot is on the
touch control panel. Wait
5minutes for c ontrol panel to
cool. If “F4” appears after turning
the surface cooking area back on,
call customer service.
F8 The surface
cooking area has
been in operation
for too long.
The surface cooking area
automatic shutoff was activated.
Turn off the surface cooking area.
c1 The power
voltage is too
low.
Turn off the cooktop. Wait
5seconds, then turn it back on. If
this continues, contact a qualified
electrician.
c2/c3 The surface
cooking area has
overheated.
The surface cooking area
automatic shutoff was activated.
Wait 5 minutes, for it to cool
down, then turn it back on.
Is the display flashing “Er” and numbers?
If an “Er” and a series of numbers appear in
the display panel, turn power off at the circuit
breaker. Turn on again. If a problem contin-
ues, call customer service. See “Assistance
or Service” in the Use & Care Guide.
Is the display flashing “F” and numbers?
If “F” and a number are alternately flashing
on the display, refer to the following table for
possible solutions.
•
•
Operational cooktop sounds
Is there a low humming? This occurs when
cooking at high power. The cause of this is
the amount of energy which is transmitted
from the appliance to the cookware. This
sound will quiet or go away when the power
is turned down.
Is there a crackling? This sound occurs
when cookware is used which consists of
different materials. The noise is caused by
vibrations in the joint faces between the dif-
ferent layers. It may change depending on the
amount and type of food being cooked.
Is there a fan noise? The electronics re -
quire a controlled temperature in order to
function reliably. The cooktop is fitted with a
fan which runs at various speeds according
to the temperature detected. The fan may
also continue to run even after the cooktop
has been switched off, if the temperature it
detects is too high.
•
•
•