KitchenAid KSM7990 manual Care and Cleaning, To remove the Bowl Support for cleaning

Care and Cleaning

•Unplug the Stand Mixer before cleaning or disconnect power.

•Stainless steel bowl, flat beater, wire whip, and spiral dough hook may be washed in an automatic dishwasher. Or, clean them thoroughly in hot sudsy water and rinse completely before drying. Do not store beaters on shaft.

•The bowl is dishwasher-safe. It can also be hand-washed in hot sudsy water, rinsed thoroughly, and dried.

•Wipe the Stand Mixer with a clean damp cloth. Do not use abrasive cleansers or scouring pads and do not immerse the Stand Mixer in water.

•Wipe the beater shaft frequently, removing any residue that may accumulate.

To remove the Bowl Support for cleaning

1.Unplug Stand Mixer or disconnect power.

2.Remove the Stand Mixer base by removing the 3 screws located on the bottom of the mixer. Remove the vent screen and the mixer base.

3.Remove the nut from the lifter rod located inside the column, then remove the washer and spring.

NOTE: Note the order that they were assembled (the washer goes between the spring and nut), for reassembly.

Nut

4.Loosen the screw holding the bowl clip to the front of the bowl support – it is not necessary to remove the screw all of the way. This allows the bowl support to slide down.

Screws

Screw

15