Install Drawer Front Panels and Toe Panel

Option 1: Install standard front panels

1. Remove front panels from box and discard all shipping
material.
2. On the shorter front panel (lower drawer), remove the
tape securing the connector and wires. Discard tape.
3. Connect the end of the medallion connector to the
connector from the lower drawer.
4. Gently feed the wires and connectors into the metal plate
wire opening.
5. Line up front panel tabs to slots in metal plate. Do not
pull the connector from wire opening.
6. Push the front panel down to lock in place.
7. Repeat steps 2–6 for the top drawer panel.
8. When installed properly, top panel should be even with
top of dishwasher with a 3/8" (9.5 mm) gap between the
top and bottom panel.
5. Attach the drain hose connector to the air break using
the supplied hose clamp.
11
waste
valve
air break
drain hose
connector
water supply
8" (20.3 cm) min. bend
radius from valve
Connect to Water Supply
1. Install the flat seal washer on the end of the inlet hose.
Connect the inlet hose to the water supply valve. Tighten
securely.
2. Turn the water valve on and check for any leaks.
3. Open top drawer. Remove the packing tape from the front
and rear of dish rack.
4. Close drawer.
5. Open bottom drawer. Remove the packing tape from the front
and rear of dish rack.
6. Close drawer.
flat seal
washer
valve
inlet hose
wire
opening
end of medallion
connector
metal
plate
lower front
panel
slots
metal plate
front panel
tabs
YD40643/8546448_E_non-RFI 10/1/04 9:42 AM Page 11