![](/images/new-backgrounds/1041456/4145615x1.webp)
Freestanding Ranges:
1.Measure the distance of the countertop to the floor.
2.Then measure from the top of the range cooktop trim to the floor.
A
A. Distance from the top of the range cooktop trim to the floor
3.Your leveling height will be the difference between the 2 measurements you have just taken.
Adjust LevelingLegs
1.If range height adjustment is necessary, use a wrench or pliers to loosen the 4 leveling legs.
This may be done with the range on its back or with the range supported on 2 legs after the range has been placed back to a standing position.
NOTE: To place range back up into a standing position, put a sheet of cardboard or hardboard in front of range. Using 2 or more people, stand range back up onto the cardboard or hardboard.
2.Adjust the leveling legs to the correct height. Leveling legs can be loosened to add up to a maximum of 1" (2.5 cm). A minimum of ³⁄₁₆" (5 mm) is needed to engage the
NOTE: If height adjustment is made when range is standing, tilt the range back to adjust the front legs, then tilt forward to adjust the rear legs.
3.When the range is at the correct height, check that there is adequate clearance under the range for the
Install Anti-TipBracket
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
Contact a qualified floor covering installer for the best procedure for drilling mounting holes through your type of floor covering.
Before moving range, slide range onto shipping base, cardboard or hardboard.
1.Remove template from the
2.Place template on the floor in cabinet opening so that the left edge is against cabinet and top edge is against rear wall, molding or cabinet.
3.Tape template in place.
4.If countertop is not flush with cabinet opening edge, align template with overhang.
If cabinet opening is wider than specified in the “Location Requirements” section, adjust template so range will be centered in cabinet opening.
5.To mount
To mount
8