Electrical Requirements
Observe all governing codes and ordinances. The microwave oven is connected to a
GROUNDING INSTRUCTIONS
■For all cord connected appliances:
The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified
PARTS AND FEATURES
A | G | |
B |
| |
C | H | |
| I | |
D | J | |
K | ||
| ||
E |
|
electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven.
■ For a permanently connected appliance: |
This appliance must be connected to a grounded, |
metallic, permanent wiring system, or an equipment |
grounding conductor should be run with the circuit |
F
A. Lower oven control (on some models)
B. Door safety lock system C. Microwave oven light D. Glass turntable
E. Metal shielded window F. Door handle
G. Microwave oven control panel
H. Quartz broil element (hidden in ceiling, near door)
I. Convection element and fan (not visible - on some models)
J. Cooking guide label
K. Removable turntable support
Parts and Features not shown
Oven vent (behind door handle)
conductors and connected to the equipment grounding |
terminal or lead on the appliance. |
SAVE THESE INSTRUCTIONS
This device complies with Part 18 of the FCC Rules.
Turntable
A 
B 
C
D
A.Turntable
B.Hub
C.Support
D.Shaft
The turntable rotates in both directions to help cook food more evenly. Do not operate the microwave oven without the turntable in place. See “Assistance or Service” to reorder any of the parts.
To Install:
1.Remove tape from the hub.
2.Place the support on the microwave oven cavity bottom.
3.Place the turntable on the support.
Fit the raised, curved lines in the center of the turntable bottom between the three spokes of the hub. The rollers on the support should fit inside the turntable bottom ridge.
5
