Instrument
Familiaris
a
t
ion
:
R
ear
Panel 
Controls
19 | 26 | 22 | 23 |
C US
12
3
NEUTRIK | NEUTRIK |
12
3
NEUTRIK | NEUTRIK |
20 | 21 | 24 | 25 |
19.Mains is supplied via an IEC standard
20.The mains fuse is located in a fuse holder fitted to the rear panel. Always replace with the correct type and rating as indicated on the unit.
21.Voltage selector switch. This unit is switchable between two nominal supply voltages, 110V and 220V, via a slide switch. The switch MUST be set before the supply is connected. Any attempt to run
the unit from a 220V supply with the switch set to 110V is liable to result in severe damage to the unit.
Note: Units for the Japanese market do not have an accessible mains voltage selector switch and are set for 100V operation only.
22.Signal Input is made via a female XLR type connector.
23.Signal Output is available on a male XLR type connector. For wiring details see page 11 of this manual.
24.Expander Side Chain Input is made via a ¼ inch type A stereo jack connector.
25.Compressor Side Chain Input is made via a ¼ inch type A stereo jack connector.
26.Always quote the Serial Number in any correspondence concerning the unit.
9
