Klipsch P-312W Remote Control Operation, Volume +, X-over+, Phase +, ARC On/Off, Presets, EQ Mode

Page 12

Remote Control Operation

This section describes the features found on the supplied remote control for your Palladium P-312W subwoofer. The remote control works via infrared and, as such, will need a clear line of sight to the infrared receiver located on the lower right quadrant of the front panel. The remote will work with or without the front-panel grille installed. The codes from the remote can be programmed into any standard learning remote control if your system includes such a device.

Volume + / -

These buttons adjust the level of the sub- woofer up and down as described in the “Volume” control section of this manual.

X-over + / -

These buttons adjust the frequency of the lowpass filter up and down as described in

the “Lowpass” control section of this manual.

Phase + / -

These buttons adjust the phase control up and down as described in the “Phase” control section of this manual.

ARC On/Off

This button toggles the ARC feature on and off as described in the “Room Correction” control section of this manual.

EQ Mode

These buttons provide direct access to any of the three EQ modes as described in the “EQ Mode” control section of this manual.

Presets

These buttons provide direct access to any of the five presets as described in the “Recall Settings” and “Save Set- tings” control sections of this manual.