Klipsch P-312W Preparing the Loudspeaker, Connection Procedure, Fitting and Removing the Grilles

Page 4

Preparing the Loudspeaker

Connection Procedure:

There is a specific procedure to be followed:

•Switch off and unplug the amplifier/s and all source electronics from the mains power.

•Place the subwoofer in the general area where you want it.

•Connect the subwoofer following the instructions under the “connecting the subwoofer” section of this manual.

•Finalize the position of the loudspeakers.

•Fit the front grille (if desired)

TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE SUBWOOFER AROUND.

TO PRESERVE THE FINISH, WHEN HANDLING YOUR SUBWOOFER USE THE GLOVES THAT ARE PROVIDED.

Fitting and Removing the Grilles

To fit the front grille: align the posts on the grille with the post cups on the front of the subwoofer and gently press on the grille. Use care to ensure that the grille clears the aluminum control panel extrusion area around the logo. Do not strike or forcibly press on the grille or grille posts as damage to the grille or finish of your subwoofer could occur.

The round side grilles cover the two passive radiators and come pre-installed from the factory. They are attached via rubber capture posts to special fasteners on the passive radiators. If these grilles should ever need to be re- installed, make sure you orient them properly so that the curve of the grille follows the curve of the subwoofer side panel and gently press them back into place.

Although operating the P-312W subwoofer with the front grille on or off is a matter of personal taste, moving or connecting the subwoofer should always be done with the front grille removed. Be especially careful not to touch the drive unit.