Klipsch SB 1 Soundbar Front Status Lights Source Mute, Volume Up Volume Down, Soundbar Rear

This device complies with part 15 of the FCC Rules and the applicable Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :

(1)l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.

This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with mini- mum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Cet appareil est conforme à FCC et IC l’exposition aux rayonnements limites fixées pour un environnement non contrôlé. Cet appareil doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps. Cet transmetteur ne doit pas être co-situé ou opérant en liaison avec toute autre antenne ou transmetteur.

Soundbar Front

Status Lights

Source

Mute

Volume Up

Volume Down

Soundbar Status Light

RED: In STANDBY (“Sleep”) Mode

GREEN: On Digital Optical Cable Input

ORANGE: On Analog RCA L/R Input

GREEN (Flashing): Digital Input muted

ORANGE (Flashing): RCA Input muted

RED (Flashing): Failure to learn a remote control command

GREEN OR ORANGE FLASHES: A remote control signal has been received

WHITE (Right Status Light):

In 3D Surround Mode

RED and GREEN (Alternating):

Remote programming mode activated

National REstrictions

This device is intended for home and office use in all EU countries (and other countries following the EU directive 1999/5/EC) without any limitation except for the countries mentioned below:

Country	Restriction	Reason/remark
Bulgaria	None	General authorization required for outdoor use and
		public service
	Outdoor use limited	Military Radiolocation use. Refarming of the
France	to 10 mW e.i.r.p	2.4 GHz band has been ongoing in recent
	within the band	years to allow current relaxed regulation. Full
	2454-2483.5 MHz	implementation planned 2012
Italy	None	If used outside of own premises, general
		authorization is required
Luxembourg	None	General authorization required for network and
		service supply (not for spectrum)

Soundbar Rear
Analog RCA Inputs	Power Supply Input
1 SOURCE 2	DC IN

R
			POWER
	24V – 2.5A
L	65W	OFF	ON

Digital Optical	Main Power
Cable Input

		This subsection does not apply for the
Norway	Implemented	geographical area within a radius of 20 km from
		the centre of Ny-Álesund
Russian Federation	None	Only for indoor applications

Note: Please don’t use the product outdoors in France

Manufactured under license from Dolby Laboratories. Dolby and the double-D symbol are registered trademarks of Dolby Laboratories.

PAcking List

1.	Soundbar
2.	Wireless subwoofer
3.	Soundbar power supply/power cord
4.	Subwoofer power cord

Subwoofer Rear

SUBWOOFER
	VOLUME
MIN	MAX
POWER
ON	OFF	AC~100-240V
		50/60Hz
		90W

Volume Control

Status Light

Main Power ON/OFF

Power Cord Input

5.	One 4.9 foot (1.5m) Digital optical cable
6.	One Dual RCA Cable
7.	One Remote Control
8.	Quick Setup Guide
9.	Soundbar wall-mount template
10. This Owner’s ManuaL

Subwoofer Status Light

BLUE (Solid): Receiving wireless signal from soundbar

RED (Solid): Searching for soundbar wireless signal