Knoll Systems US-P3, US-V3, UR-P3 Dlp-Tv, Power supply, PS1202, gives power, for UR-V3, DVD Player

Wiring: A send module (US-P3 or US-V3) needs to be connected to a Knoll receive module (UR-

P3 or UR-V3) to work correctly. The send and receive module are connected using

a single cat 5 wire using all 8 conductors. Connection is made with the RJ45 connector (RJ45 plug not supplied). Always use standard cat 5 wiring practices. Using the correct wire pairs and polarity is VERY important.

Connection to stereo video source equipment: Connect the three US-P3 or US-V3 gold RCA jacks with a good quality gold connector triple wire component RCA jumper cable to the appropriate three component output jacks on your DVD, dish receiver, D-VHS, VCR, stereo or other equipment.

If there is a switched outlet on your output equipment, you may want to plug the PS1202 power supply to the switched outlet.

Make sure a good quality RJ45 8-8 crimper is used to connect the RJ45 connector to the cat 5 wire. Poor crimping and mismatched wires are the biggest cause of installation problems.

Power requirements: The Knoll balun system requires a single PS1202 power supply connected to the send unit only. In certain cases with very long leads a higher voltage PS1506 15 VDC power supply may be required if wavy or image video lines are evident.

Connection to the Projector, TV or other components: Connect the three US-P3 or US-V3 gold RCA jacks with a good quality gold connector triple wire component RCA jumper cable to the appropriate three component input jacks on your projector, plasma, TV or other component. Make sure the correct projector, plasma, TV or other component input is selected.

Multiple Connection(s): If the component signal needs to be sent to more than one receiver, this can easily be accomplished by daisy chaining the Knoll component senders. The US-P3 and/or US-V3 sender RCA inputs need to have their three RCA inputs Y-corded together. Each sender is connected via one cat 5 wire to one UR-P3 or UR-V3 receiver (as above). Three resistors in all but one of the senders need to be snipped. For example, if four senders are being Y-corded together, three (not all four) of the US-P3 and/or US-V3 senders need to be opened up and have the three 75 ohm through hole resistors beside the RCA jacks snipped off. Receive units do not have any alterations. Each send unit requires a PS1202 power supply.

To loop from a local source going to a local component (such as a TV) using Y-cords, the three 75 ohm resistors in the send unit MAY need to be snipped.

The Knoll send receive system does not have any user adjustments and is completely automatic. If need be, please call our tech line for details at 1 800 566 5579.

This product may contain lead that some states have determined are harmful. Wash you hands after touching this product.

Decora™ is a trademark of Leviton

DVD Player
	CAT 5
	US-P3
	Power supply
PS1202	gives power
	for UR-V3

DLP-TV

UR-V3

Power is supplied by US-V3