UNDER THE CABINET INSTALLATION – REAR VENT
Preparation before installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
-Decide the location of the venting pipe from the hood to the outside. Refer to Figure 6.
-A straight, short venting run will allow the hood to perform more efficiently.
-Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood.
-Temporarily wire the hood to test for proper operation before installing.
-Peel protective film off the hood (if any).
-For installing under the cabinet with recessed bottom, attach
-Measure and create access opening for electrical wires under the cabinet or access opening for the electrical wires at the rear of the hood.
-Remove the screws on the vent cover (rear) and cut along the line of the inner vent cover (rear) opening. Refer to Figure 8.
-Cut the vent cover (rear) opening and reverse to the other side. Refer to Figure 9. Reattach the vent cover (rear).
Figure 6
Inner Vent
Cover (Rear)
Figure 7
Reversed
Vent Cover
(Rear)
Figure 8 | Figure 9 |
8
