Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
Connect the electrical wires.
-If necessary to hide the electrical wire connections, push wires back into the wiring box. Access the wire connections underneath the hood by removing the bottom casing from the six screws. Before reattaching the bottom casing, make sure wires do not slip between motors, impellers, or any moving parts to prevent any damage.
-Connect three wires (black, white and green) to house wires and cap with wire connectors.
-Connect according to color: black to black, white to white, and green to green.
-Test the operation of the hood before moving on to the next step. Make sure power is supplied to the hood.
Install Accessories
1.Attach oil tunnel. Refer to Figure 30.
2.Refer to Figure 31. Slide the baffle filter into the hood. Push the baffle filter upward. Slide forward. Pull downward. Fit into place.
3.For bottom casing, repeat above steps.
Final Assembly
4.Turn power ON in control panel. Check all lights and fan operation.
5.Make sure to leave this manual for the homeowner.
Figure 30
Figure 31
16
