mounting screws (not provided) on the wall, leaving 1/8” away from the wall.
2.Align
3.For safety purposes, extra knockout holes on the back of the hood are provided. Knockout the holes. Remove the baffle filters and attach screws to the wall by accessing underneath the hood.
CAUTION: MAKE SURE HOOD IS SUCURE BEFORE RELEASING
Wiring to Power Supply
SAFETY WARNING
RISK OF ELECTRICAL SHOCK. THIS RANGE HOOD MUST BE PROPERLY GROUNDED. MAKE SURE THIS IS DONE BY SPECIALIZED ELECTRICIAN IN ACCORDANCE WITH ALL APPLICABLE NATIONAL AND LOCAL ELECTRICAL CODES. BEFORE CONNECTING WIRES, SWITCH POWER OFF AT SERVICE PANEL AND LOCK SERVICE PANEL TO PREVENT POWER FROM BEING SWITCHED ON ACCIDENTALLY.
4.Connect the electrical wires.
-Connect three wires (black, white and green) to house wires and cap with wire connectors. Connect according to color: black to black, white to white, and green to green as shown on Figure 12.
-If necessary to hide the electrical wire connections, push wires back into the wiring box. Access the wire connections underneath the hood. Make sure wires do not slip between motor or any moving parts to prevent any damage.
Duct Cover Installation
5.Mark the position of the duct cover- mounting bracket. Use reference E from Table 2 and measurements on page 16- 17. Attach and secure duct cover- mounting bracket with two screws (not provided). Refer to Figure 13. NOTE:
Inner duct cover will cover the duct cover- mounting bracket.
Figure 12
Figure 13
Figure 14
Figure 15
10