Manuals / Kobe Range Hoods / Kitchen Appliance / Ventilation Hood

Kobe Range Hoods IS2442GSB, IS2436GSB Safety Warning, Installation, Bottom Recommended 30” to 36”

Models: IS2436GSB IS2442GSB

1 24

Download 24 pages 13.44 Kb

Page 6

Image 6

INSTALLATION

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING

Calculation before Installation

To calculate installation, please refer to TABLE 1. (All calculation in inches.)

TABLE 1

A = Height of Floor to Ceiling

B = Height of Floor to Counter Top (Standard: 36”)

C = Preferred Height of Counter Top to Hood

Bottom (Recommended 30” to 36”)

D = Height of Hood

E = Height of the Hood Installation

[A – (B+C)]

F = Height of Duct Cover

[E – D]

SAFETY WARNING

HOOD MAY HAVE VERY SHARP EDGES; PLEASE WEAR PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY PARTS FOR INSTALLING, CLEANING OR SERVICING.

NOTE: BE CAREFUL WHEN USING ELECTRICAL SCREWDRIVER, DAMAGE TO THE HOOD MAY OCCUR.

Page 6

Image 6

Kobe Range Hoods IS2442GSB, IS2436GSB Safety Warning, Installation, C = Preferred Height of Counter Top to Hood

Contents

KOBE Brand Range Hood Model No. IS2436GSB IS2442GSB IS-124 SERIES“ISLAND GLASS CANOPY WITH LCD SCREEN” READ AND SAVE THESE INSTRUCTIONS CONTENTSALL WIRING MUST BE DONE BY A PROFESSIONAL AND IN READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTINGIMPORTANT SAFETY INSTRUCTIONS PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATIONWhat to Do In The Event Of a Range Top Grease Fire BOX 2 OF MODEL NO. IS124DC COMPONENTS OF PACKAGEBOX 1 OF MODEL NO. IS2436GSB MODEL NO. IS2442GSB Must keep all material for returns or refundsC = Preferred Height of Counter Top to Hood SAFETY WARNINGINSTALLATION Bottom Recommended 30” to 36”Preparation before Installation Advance PlanningImportant Peel protective film off the hood and duct covers, if any Ductwork Installation Telescopic Stack InstallationWiring to Power Supply SAFETY WARNINGConnection to LCD Screen Duct Cover InstallationFinal Assembly SAFETY WARNINGOPERATION INSTRUCTIONS LCD DISPLAYWhen appears, keypad sound is ON 1. Press until flashesTurning ISC Integrated Sensor Control ON/OFF Setting Delay ModeSetting Timer Mode Turning Lights ONTo Clean Hood Surface MAINTENANCESAFETY WARNING CAUTION NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHSTo Replace Light Bulb CAUTION HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOLSPECIFICATIONS MEASUREMENTS & DIAGRAMS Sold SeparatelyMODEL NO. IS2436GSB PARTS LISTBox 1 of MODEL NO. IS2442GSBBOX 2 OF 2 - DUCT COVER MODEL NO. IS2436GSB IS2442GSBBOX 1 OF 2 - GLASS CANOPY WITH LCD SCREEN OPTIONALCIRCUIT DIAGRAM 2. PLEASE INSPECT CONTENTS OF PACKAGE S CAREFULLY UPON RECEIPT DISCLAIMERDAMAGES CAUSED DURING TRANSIT ARE NOT COVERED UNDER OUR WARRANTY CLAIMS WILL NOT BE ACCEPTED AFTER THE ALLOCATED DAYSTWO-YEAR WARRANTY SERVICE PERIOD WARRANTYWARRANTY CERTIFICATE CONDITIONSSERVICE CONSEQUENTIAL DAMAGEIMPLIED WARRANTIES/STATE LAW PRODUCT REGISTRATION Register Your ProductRECORD THE FOLLOWING INFORMATION FOR YOUR RECORD KOBE Range Hoods 10505 Valley Blvd Suite # El Monte, CA 91731 USA