Manuals / Kobe Range Hoods / Kitchen Appliance / Ventilation Hood

Kobe Range Hoods IS2442GSB, IS2436GSB installation instructions To Replace Light Bulb

Models: IS2436GSB IS2442GSB

1 24

Download 24 pages 13.44 Kb

Page 14

To Replace Light Bulb

To Replace Light Bulb

CAUTION: HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL.

1.Make sure all controls are OFF, and range hood is unplugged.

2.Place the flat-head screwdriver into the groove between the halogen light glass covering and the housing .

3.Gently separate glass covering from the housing .

4.Gently pull out the defective light bulb and discard. Light bulbs should be 12V 20W maximum.

5.Wear a glove or use a cloth to hold the new light bulb and push securely into light socket.

NOTE: DO NOT PUSH TOO HARD OR YOU MAY BREAK THE BULB CONNECTOR.

6.Put back halogen light glass cover .

7.Plug back power cord and turn on range hood to test for operation.

12

Image 14

Kobe Range Hoods IS2442GSB To Replace Light Bulb, Caution Halogen Light Unit May Be Hot! Wait Until Unit Is Cool

Contents

“ISLAND GLASS CANOPY WITH LCD SCREEN” KOBE Brand Range HoodModel No. IS2436GSB IS2442GSB IS-124 SERIES READ AND SAVE THESE INSTRUCTIONS CONTENTSALL WIRING MUST BE DONE BY A PROFESSIONAL AND IN READ ALL INSTRUCTIONS CAREFULLY BEFORE STARTINGIMPORTANT SAFETY INSTRUCTIONS PLEASE READ THIS SECTION CAREFULLY BEFORE INSTALLATIONWhat to Do In The Event Of a Range Top Grease Fire BOX 2 OF MODEL NO. IS124DC COMPONENTS OF PACKAGEBOX 1 OF MODEL NO. IS2436GSB MODEL NO. IS2442GSB Must keep all material for returns or refundsC = Preferred Height of Counter Top to Hood SAFETY WARNINGINSTALLATION Bottom Recommended 30” to 36”Important Peel protective film off the hood and duct covers, if any Preparation before InstallationAdvance Planning Ductwork Installation Telescopic Stack InstallationWiring to Power Supply SAFETY WARNINGConnection to LCD Screen Duct Cover InstallationFinal Assembly SAFETY WARNINGOPERATION INSTRUCTIONS LCD DISPLAYWhen appears, keypad sound is ON 1. Press until flashesTurning ISC Integrated Sensor Control ON/OFF Setting Delay ModeSetting Timer Mode Turning Lights ONTo Clean Hood Surface MAINTENANCESAFETY WARNING CAUTION NEVER USE ABRASIVE CLEANERS, PADS, OR CLOTHSTo Replace Light Bulb CAUTION HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOLSPECIFICATIONS MEASUREMENTS & DIAGRAMS Sold SeparatelyMODEL NO. IS2436GSB PARTS LISTBox 1 of MODEL NO. IS2442GSBBOX 2 OF 2 - DUCT COVER MODEL NO. IS2436GSB IS2442GSBBOX 1 OF 2 - GLASS CANOPY WITH LCD SCREEN OPTIONALCIRCUIT DIAGRAM 2. PLEASE INSPECT CONTENTS OF PACKAGE S CAREFULLY UPON RECEIPT DISCLAIMERDAMAGES CAUSED DURING TRANSIT ARE NOT COVERED UNDER OUR WARRANTY CLAIMS WILL NOT BE ACCEPTED AFTER THE ALLOCATED DAYSTWO-YEAR WARRANTY SERVICE PERIOD WARRANTYWARRANTY CERTIFICATE CONDITIONSIMPLIED WARRANTIES/STATE LAW SERVICECONSEQUENTIAL DAMAGE RECORD THE FOLLOWING INFORMATION FOR YOUR RECORD PRODUCT REGISTRATIONRegister Your Product KOBE Range Hoods 10505 Valley Blvd Suite # El Monte, CA 91731 USA