Duct Cover Installation
6.Use 8” round steel pipe (follow building codes in your area) to connect the ducting transition on the hood to the ductwork above. Use duct tape to make all joints secure and air tight. Refer Figure 7.
7.Use four 3/16” x 3/8” screws (included) to attach duct cover to hood. Refer to Figure 8.
Install Accessories
8.Attach oil tunnel. Refer to Figure 9.
9.Refer to Figure 10. Slide the baffle filter into
the hood. | Push the baffle filter upward. | ||
Slide forward. | Pull downward. | Fit into | |
place. |
|
|
|
10.For bottom casing, repeat above steps. Refer to Page 15.
Final Assembly
11.Turn power ON in control panel. Check all lights and fan operation.
12.Make sure to leave this manual for the homeowner.
Figure 8
Figure 9
Figure 10
8
