CLEANING THE NOZZLE:
The nozzle hose carries the dirt from the nozzle to the dust bag, and also fuctions as the attachment cleaning hose.
If it should become clogged:
Model U-800
1.Unplug the power cord.
2.Lift up the lid of cleaning attachment opening. Remove the clog or blockage.
3.If the previous step does not correct the problem, pull the power nozzle from the cleaning attachment opening located at the base of the vacuum cleaner. Turn the unit over and remove the bottom plate (see page 14 removing the bottom plate), unscrew the hose inlet fitting screw, then pull out the entire nozzle hose from the housing. Clear the obstruction from the hose assembly, replace the hose in the housing and reinstall the bottom plate. See step 10 on page 15.
Model U-900
1.Unplug the power cord.
2.Open the lid on the cleaning attachment opening and remove the clog or blockage.
3.If the hose is still blocked, remove hose cuff from nozzle inlet.
4.Turn the unit over, remove bottom plate.
5.Check nozzle inlet tube for obstructions.
6.When clear, reinstall bottom plate. See instructions on page 15. Replacing the drive belt.
• Any other servicing should be performed by an Authorized Vacuum Cleaner service center.
