Dragonfly/Butterfly Installation Guide | Safety Information |
| |
|
|
1.1Warnings
Cleaning after soldering
To avoid the damage of the product's acrylic coating the Dragonfly/Butterfly must not be cleaned after soldering by dissolving solvents and /or "water" cleaning process. For more details:
To avoid electric arcing and hazards to personnel and electrical contacts, never connect/disconnect the servo drive while the power source is on.
Power cables can carry a high voltage, even when the motor is not in motion. Disconnect the Dragonfly and Butterfly from all voltage sources before they are opened for servicing.
The Dragonfly and Butterfly servo drive contain grounding conduits for electric current protection. Any disruption to these conduits may cause the instrument to become hot (live) and dangerous.
After shutting off the power and removing the power source from your equipment, wait at least 1 minute before touching or disconnecting parts of the equipment that are normally loaded with electrical charges (such as capacitors or contacts). Measuring the electrical contact points with a meter, before touching the equipment, is recommended.
1.2Cautions
The Dragonfly and Butterfly servo drives contain hot surfaces and
The maximum DC power supply connected to the instrument must comply with the parameters outlined in this guide.
When connecting the Dragonfly and Butterfly to an approved 12 ~ 95 VDC auxiliary power supply, connect them through a line that is separated from hazardous live voltages using reinforced or double insulation in accordance with approved safety standards.
Before switching on the Dragonfly and Butterfly, verify that all safety precautions have been observed and that the installation procedures in this manual have been followed.
