Troubleshooting
www.kodak.com/go/support 43
Picture is too
light.
The subject was too
close for flash.
Move so there is at least 2 ft
(0.6 m) between camera and subject.
The light sensor is
covered.
Hold the camera so your hands or other
objects do not cover the light sensor (pagei).
Too much light. Decrease Exposure Compensation (page18).
Auto exposure was
not achieved.
To take the best possible pictures, press the
Shutter button halfway and hold. When
the ready light glows green, press the Shutter
button the rest of the way down to take
the picture.
Picture is not
clear.
The lens is dirty. Clean the lens (page52).
Subject too close
when taking picture.
Move so there is at least 23.6 in. (60 cm)
between the camera and the subject, or at
least 5 in. (13 cm) at Wide in Close-up mode.
Subject or the camera
moved while the
picture was taken.
Place the camera on a flat, steady surface or
use a tripod.
Auto-focus was not
achieved.
To take the best possible pictures, press the
Shutter button halfway and hold. When
the ready light glows green, press the Shutter
button the rest of the way down to take
the picture. (If the orange light blinks, release
the Shutter button and recompose picture.)
Camera is in Close-up
mode.
Use Close-up mode when subject is 5-28 in.
(13-70 cm) from the lens in Wide Angle; 9-28
in. (22-70 cm) in Telephoto.
The camera
does not
recognize SD or
MMC card.
The card may not be
SD or MMC certified.
Purchase a certified SD or MMC card.
The card may be
corrupt.
Reformat the card (page22).
Caution: Formatting deletes all pictures and
videos, including protected files.
Card is not properly
inserted in camera.
Insert a card into the slot, then push to seat
(page7).
Problem Cause Solution