INSTRUCTIONS
Using KODAK PROFESSIONAL READYLOAD
Single-Sheet Packets in the KODAK PROFESSIONAL
READYLOAD Packet Film Holder
To expose the film, follow these steps:
1.Grasp the end of the packet and insert it into the holder until it comes to a firm stop.
2.When you are ready to expose the film, grasp the end of the outer protective envelope as shown and pull it out until it stops. You should see part of the stop zone.
Do not squeeze the release bar during this step.
6.Wrap an “Exposed” sticker around the end of the packet with the metal clip.
Stop Zone
3.Expose the film as you normally do.
4.Push the outer envelope all the way into the holder until it comes to a firm stop. Do not squeeze the release bar during this step.
5.To remove the packet from the holder, squeeze and hold the release bar. Then grasp the end of the packet as shown, and pull it straight out. Do not bend the packet when you remove it from the holder.
2 | Using the KODAK PROFESSIONAL READYLOAD |
