Kodak SRP 30 manual Coding the Paper Magazine, Width Indicators Surface Indicators Paper Width

Operator’s Guide

Coding the Paper Magazine

White slide tabs located on the paper magazine let you code the width (1–4) and surface (5–6) of the paper in use. Whenever you change paper, set the slide tabs accordingly. The meaning of the coding is described below.

†Slide tab closed (corresponds to switch setting on the SRP 30 screen)

„Slide tab open (corresponds to switch setting on the SRP 30 screen)

			Width Indicators			Surface Indicators
Paper Width
		1	2	3	4	5	6
3.25 inch	(82 mm)	„	†	„	†
3.50 inch	(89 mm)	„	†	„	„
3.75 inch	(95 mm)	†	„	„	„
4.00 inch	(102 mm)	„	„	„	†
4.75 inch	(120 mm)	„	„	†	„	GLOSSY	„†
5.00 inch	(127 mm)	„	†	†	„	MATTE	„„
6.00 inch	(152 mm)	„	†	†	†	CUSTOM1	†„
6.50 inch	(165 mm)	†	„	„	†	CUSTOM2	††
7.00 inch	(178 mm)	†	„	†	„
8.00 inch	(203 mm)	†	†	„	„
8.25 inch	(210 mm)	†	„	†	†
8.50 inch	(216 mm)	†	†	†	†
10.0 inch	(254 mm)	†	†	†	„
11.0 inch	(279 mm)	†	†	„	†
12.0 inch	(305 mm)	„	„	†	†

NOTE: The table shows the Kodak standard. If required, you can define a different allocation of the switches to paper widths and surfaces. Each switch combination can only be used once.

When the magazine is in place, the system automatically recognizes the paper width and the paper surface and offers them for selection in the print menus.

For more information, see Defining Surfaces, Defining Paper Settings, and Paper Configurations in Chapter 4.

6-6 KODAK PROFESSIONAL SRP 30 Laser Printer