3.0 OPERATION. Cond...
3.5
OPERATING THE REMOTE CONTROL (OPTIONAL).
3.5.1.FUNCTIONS
The remote control can be used to control all the whirlpool functions.
The whirlpool can be turned on and off using the power button on the remote control.
The M (mode) key is used to scroll through the available functions.
The icons on the dial control indicate the functions as detailed on previous page.
Pressing O.K. or arrow up key on the remote control will select a particular function.
Two 1.5V AAA alkaline batteries are supplied fitted in the remote control. To replace, simply unscrew the bottom end cap and insert the batteries. Tighten the end cap securely making sure that the end cap makes contact with the seal.
3.5.2.PROGRAMMING
Programming your remote control is normally not required. If more than one device in your home, or in the near vicinity of your home, uses a remote control, it may be necessary to program this remote control to the user key pad. If you replace your remote control, or replace the controller, it may be necessary to program the remote control.
Programming steps:
1.Turn power on to the whirlpool.
2.Turn off all modes of operation. Wait approximately one minute until the dial control key pad darkens completely.
3.On the Dial Control press the up arrow, down arrow and the OK buttons simultaneously. The
Power
OK | UP | |
Button | ||
| ||
Mode | DOWN | |
Button | ||
|
Remote 
Base
-
+ +
- |
| 1.5 V AAA |
|
| |
|
| Alkaline battery |
|
|
Kohler Co. | Page 10 | Part No |
