Kathrein UFS 821si TV and Video Recorder Connection, Audio Connection, Optical Digital Output

Connection and Setup

	Though a restriction on this is that with tuner 2 you can only receive the
	additional channels of the plane currently set by tuner 1 (e.g. Horizontal
	High).
	This will only work when receiving one satellite, not in multifeed
	reception!
Note:	If only tuner 1 is connected (with no connection to tuner 2), the “Single
	Mode” setting must be selected for the tuner input. You can then have

only the possibilities offered by a normal “single” receiver available to you.

If this setting is not made, malfunctions will occur and the following message will be displayed:

No signal!

TV and Video Recorder Connection

Connect the satellite receiver (TV Scart socket) and the TV set by a Scart cable (see “Connection example”).

If your TV has a stereo feature, you can receive the sound in stereo via the Scart connection.

Connect the satellite receiver (VCR/AUX Scart socket) and the video recorder/PVR likewise by a Scart cable.

For system reasons, the same video signals are to be found on the Scart outputs and on the video cinch output.

If you are recording using an external video recorder, remember not to operate the receiver during recording, otherwise all the on-screen displays will appear on your recording.

Audio Connection

If you want to play the sound on your hi-fi system, connect the audio cinch sockets to the input sockets on the hi-fi system with an appropriate cable (see “Connection Example”).

Optical Digital Output

The fibre-optic output is intended for the connection of a Dolby Digital system (see “Connection Example”).

Inserting Batteries in the Remote Control

Remove the cover on the rear of the remote control.

Insert the two supplied batteries into the remote control. Ensure correct polarity of the batteries; the + and – markings are indicated inside the battery compartment.

Slide the cover back into the housing until it locks in place.

Used batteries are special waste!

Do not throw spent batteries into your domestic waste; take them to a collection point for old batteries!

Electronic equipment is not domestic waste - in accordance with directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL dated 27th January 2003 on used electrical and electronic equipment, it must be disposed of properly.

At the end of its service life, take this unit for disposal at a relevant official collection point.

11