Remote Control
Remote control RC 660
The RC 660 remote control supports up to four devices (supplied as standard with the RC 660) as well as the receivers of the UFD 5xx (not UFD 552, 554, 558) and UFD 4xx families.
First switch all receivers off at the power switch.
To configure a receiver to an infrared code:
Switch on the relevant receiver.
On the remote control simultaneously press
Address 1 = + +
Then switch the receiver off again at the power switch and do the same for the other units ( + + for second receiver; + + for third receiver and + + for fourth receiver).
Make sure only one receiver is on at a time!
To switch the remote control to an infrared code:
When you have configured all receivers to their infrared code, to switch between units on the remote control do the following:
For the first receiver’s remote (address 1) press + ; for the second receiver + ; for the third receiver + ; and for the fourth receiver + .
+ = Kathrein UFD 5xx code for remote control RC 400 The RC 600 and RC 650 remote controls cannot be replaced!
13
