Kathrein UFS 821si, UFS 821sw manual LNB Type, 22kHz Control, DiSEqC Input

First Installation

Press the  and  buttons here to select the satellite configuration for each satellite you previously selected.

LNB Type:

Press  to open the LNB Settings menu. Use the  buttons to make your selection. To confirm your selection use the  buttons to select “OK”

and press .

- Single (LNB Low frequency 9750 MHz)

- Dual (LNB Low frequency 9750 MHz + LNB High frequency 10600 MHz)

- Universal (LNB Low frequency 9750 MHz + LNB High frequency 10600 MHz + Limit frequency 11700 MHz)

22kHz Control:

Use the  buttons to make your selection (On/ Off). The 22kHz signal is needed to switch LNBs in multifeed reception and to switch between Low and High band.

DiSEqC™ Input:

Use the  buttons to make your selection. - 1 of 4: for the first satellite of the tuner

- 2 of 4: for the second satellite of the tuner

- 3 of 4: for the third satellite of the tuner

- 4 of 4: for the fourth satellite of the tuner

- Mini A: Tone-burst control signal 1 for the first satellite of the tuner (if reception system not DiSEqC™ compatible)

- Mini B: Tone-burst control signal 2 for the second satellite of the tuner (if reception system not DiSEqC™ compatible)

- Disable: If your reception system is not DiSEqC™ compatible and only one satellite per tuner is selected.

Press the  and  buttons here to select the satellite configuration for each satellite you previously selected.

LNB Type:

Press  to open the LNB Settings menu. Use the  buttons to make your selection. To confirm your selection use the  buttons to select “OK”

and press .

- Single (LNB Low frequency 9750 MHz)

- Dual (LNB Low frequency 9750 MHz + LNB High frequency 10600 MHz)

- Universal (LNB Low frequency 9750 MHz + LNB High frequency 10600 MHz + Limit frequency 11700 MHz)

22kHz Control:

Use the  buttons to make your selection (On/ Off). The 22kHz signal is needed to switch LNBs in multifeed reception and to switch between Low and High band.

DiSEqC™ Input:

Use the  buttons to make your selection. - 1 of 4: for the first satellite of the tuner

- 2 of 4: for the second satellite of the tuner

- 3 of 4: for the third satellite of the tuner

- 4 of 4: for the fourth satellite of the tuner

- Mini A: Tone-burst control signal 1 for the first satellite of the tuner (if reception system not DiSEqC™ compatible)

- Mini B: Tone-burst control signal 2 for the second satellite of the tuner (if reception system not DiSEqC™ compatible)

- Disable: If your reception system is not DiSEqC™ compatible and only one satellite per tuner is selected.

17