First Installation

Note:

If you are unsure whether you chose the right option from a previous

 

menu, you can go back a step at any time during the first installation

 

process by pressing the button.

 

Press the buttons here to select the connection mode and signal

 

configuration for the second tuner set on the receiver by you or the

 

engineer.

 

You have the following options:

 

Connection mode for tuner 2

 

-

Separated: Tuner 2 (input) has its own signal input, i.e. a direct

 

 

connection between the antenna socket and the tuner 2 input

 

-

Loop-through: The signal currently connected to the tuner 1 loop-

 

 

through output is looped-through to tuner 2 (input). Refer also to the

 

 

section headed “Operation on one Antenna Connection”

Signal configuration for tuner 2 (only in “Separated” connection mode)

-Same with tuner 1: Both tuners are connected to the same signal source (same cable from LNB)

-Different to tuner 1: The two tuners are connected to different signal sources (separate cables from LNB)

Press to move to the next menu. The notes on the subsequent First Installation menus are divided into two columns. The left-hand column indicates the further installation procedure for the “Same with tuner 1”, signal configuration, while the right-hand column details the “Different to tuner 1” procedure.

The satellites shown in the following screenshots are factory preset. To be able to receive the satellites you want, your system must be aligned to them!

15

Page 15
Image 15
Kathrein UFS 821si, UFS 821sw manual Connection mode for tuner