Sanyo PDG-DWL2500 owner manual Remote Control Operating Range, Remote Control Code

Part Names and Functions

Remote Control Battery Installation

1	Open the battery
	compartment lid.

2	Install new batteries	3	Replace the
	into the compartment.		compartment lid.

Two AAA size batteries

For correct polarity

(+ and –), be sure battery terminals are in contact with pins in compartment.

To ensure safe operation, please observe the following precautions : • Use two (2) AAA or LR03 type alkaline batteries.

• Always replace batteries in sets.

•Do not use a new battery with a used battery.

•Avoid contact with water or liquid.

•Do not expose the remote control to moisture or heat.

•Do not drop the remote control.

•If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

•Risk of an explosion if battery is replaced by an incorrect type.

•Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Remote Control Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) when pressing the buttons. See the below figures indicating Maximum operating range for the remote control.

11.5’	16.4’
(3.5 m)	(5 m)

16.4’ (5 m)

Remote Control Code

The two different remote control codes (Code 1-Code 2) are assigned to this projector. Switching the remote control codes prevents interference from other remote controls when several projectors or video equipment next to each other are operated at the same time. Change the remote control code for the projector first before changing that for the remote control. See "Remote control" in the Setting Menu on page 58.

Press and hold the MENU and IMAGE buttons for more	MENU button
than five seconds to switch between the Code 1 and Code

2. The initial code is set to Code 1.

IMAGE button

14