Sanyo PDG-DWL2500 owner manual Appendix Indicators and Projector Condition

Appendix

Indicators and Projector Condition

Check the indicators for projector condition.

Normal Condition

Abnormal Condition

	Indicators
POWER	WARNING	LAMP	3D	Projector Condition
	TEMP..	REPLACE
Red/Green	Red	Yellow	Blue
				The projector is off. (The AC power cord is
				unplugged.)
		]	v	The projector is in stand-by mode. Press the ON/
red				STAND-BY button to turn on the projector.
		]	v	The projector is operating normally.
green
				The projector is preparing for stand-by or the
		]	v	projection lamp is being cooled down. The projector
				can not be turned on until cooling is completed and
red
				the POWER indicator stops blinking.
		]	v	The projector is in the Power management mode.
green
		]		The projector is in 3D display mode.
green
				The temperature inside the projector is abnormally
				high. The projector can not be turned on. When the
		]	v	projector is cooled down enough and the temperature
				returns to normal, the POWER indicator stops
red
				blinking and the projector can be turned on. (The
				WARNING TEMP. indicator keeps blinking.)
				The projector has been cooled down enough and
		]	v	the temperature returns to normal. When turning on
red				the projector, the WARNING TEMP. indicator stops
				blinking.
				The projector detects an abnormal condition and can
				not be turned on. Unplug the AC power cord and
		]	v	plug it again to turn on the projector. If the projector
				is turned off again, unplug the AC power cord and
				contact the dealer or the service center for service
				and checkup. Do not leave the projector on. It may
				cause an electric shock or a fire hazard.
				The lamp has been used overtime. Replace the lamp
green			v	immediately and then reset the lamp counter. The
				indicator will be turned off after resetting the counter.

• • • on. • • • blinking. • • • off

] / v • • • Differs according to conditions.

74