JVC GR-AX227 Lens Cover Switch Power, Start/Stop Power indicator Tape remaining time indicator

•The camcorder re-enters the Record-Standby mode.

NOTES:

Press the Recording Start/Stop button again to stop recording.

4

Press the Recording Start/Stop button.

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

STOP RECORDING

3

CAMERA.

•The power indicator lights and the camcorder enters the Record–Standby Mode.

•The scene you’re aimed at appears on the viewfinder screen, with the word “PAUSE” superimposed upon it.

START SHOOTING

the lens cover, then set the power switch to

Slide the LENS COVER open/close switch to open

ENTER RECORD–STANDBY MODE

1 Slide EJECT to open the cassette holder, then insert the cassette with the label facing out. Press PUSH to ensure the holder is closed and locked.

2

NOTE:

You should already have performed the procedures listed below. If not, do so before continuing.

● Power (☞ pg. 8)

● Tape Length/Recording Mode Setting (☞ pg. 11) ● Grip Adjustment (☞ pg. 12)

LOAD A CASSETTE

RECORDING

Basic Recording

14

LENS COVER

SWITCH

POWER

Start/Stop

The power indicator

Tape remaining time indicator

120MIN119MIN3MIN

1MIN (Blinking) 2MIN (Blinking)

0MIN (Blinking)

*MIN.....(Now calculating)

Tally lamp

●A cassette holder can’t be opened unless a power supply is attached.

●There may be a delay after you slide EJECT until the holder opens. Do not use force.

●The tape’s remaining time is displayed in the viewfinder as shown.

●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

●If the Record–Standby mode continues for 5 minutes, the camcorder’s power shuts off automatically. Set the power switch to POWER OFF, and then back to CAMERA to turn the camcorder on again.

●If you’re recording on a cassette from the middle, use the RETAKE function (☞ pg. 15) to find the end of the last recording so you don’t erase any of it.

●The LENS COVER warning blinks for about 5 seconds when the camcorder is turned on, whether the cover is open or closed.