KoldFront KIM450S owner manual Leveling the Ice Maker, Reversing the Door Swing, disconnect power

	Leveling the Ice Maker
	It is important for the icemaker to be leveled in order to work
	properly. It can be raised or lowered by rotating the plastic sheaths
	around each of the four feet on the bottom of the machine .If you
	find that the surface is not level, rotate the feet until the ice maker
	becomes level .You may need to make several adjustments to
	level it. We recommend using a carpenter’s level to check the
	machine.
	1. Place a carpenter’s level on top of the product to see if the ice
	maker is level from front to back and side to side .
	2. Adjust the height of the feet as follows:
	Turn the leveling feet to the right to lower that side of the ice maker
	Turn the leveling feet to the left to raise that side of the ice maker .
	IMPORTANT: Once you are ready to install it in a cabinet or directly
	on the floor, you must adjust the feet to level the ice maker. If the
	floor is level, just revolve the two front feet to touch the floor.
Door Hinge	Reversing the Door Swing
	Tools needed: flathead screwdriver, Phillips screwdriver
	IMPORTANT: Before you begin, unplug the ice maker or
Cabinet	disconnect power.
	To remove door from hinges:
	1. Using a Phillips screwdriver, remove the screws and take off top
Door	hinge. Keep the parts together and set them aside.
	3. Lift door off bottom hinge and turn it upside down so that the
	handle is on the right. Set door aside.

Door Bottom hinge

To replace door on hinges:

1.Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and bottom. Set aside.

2.Remove the bottom hinge, place on the opposite side at the bottom of the door.

3.Position the door on the bottom hinge.

4.Align the door on the bottom hinge and replace the top hinge.

5.Push the plug buttons into the original screw holes.

KoldFront Built-in Ice Maker 6