- 5-
• Replace the water tank 1back onto the appliance.
The water tank 1must audibly engage with the
unlocking device for the water tank 4.

Attaching/detaching the brush

attachment

Attention!
NEVER attempt to attach or detach the brush attach-
ment wwhen the appliance is heated up. Risk of Burns!
• To use the steam and brush function, place the
brush attachment wonto the steam brush.
• To do this, slide the brush attachment wall the
way along the guide to the end. The unlocking
device of the brush attachment qmust engage
audibly.
• To be able to use the ironing function, remove
the brush attachment wfrom the steam brush.
• To do this, press the unlocking device qdown-
wards and, at the same time, pull the brush attach-
ment waway to the front.

Steam brush function

• Place the brush attachment wonto the applian-
ce. This must engage audibly with the unlocking
device on the brush attachment q.
• Insert the power plug 7into a correctly installed
and earthed mains power socket.
• Position the temperature regulator at •••. The
heating-up control lamp 5glows. As soon as the set
temperature has been reached, the heating-up
control lamp 5goes out.
Information
When using the steam blast function, always place
the temperature regulator 3at the position ••• .
At lower settings the temperature is not sufficient to
generate a steam blast.
• By pressing the steam blast button 8you can
now produce jets of steam.
The appliance is now ready for use.
Attention!
The steam brush can be used with all clothing items.
Caution is to be exercised with heat-sensitive materials
such as synthetics, polyamides or artificial silk. With
these materials you should first check at a concealed
part (inside seam) that the hot steam will not cause
any damage to the garment. Do not touch these ma-
terials directly with the hot sole of the iron 0. Use
only the steam blast.

Clothing care

• Suspend the crumpled garment from a coat hanger.
• With one hand pull the garment flat, then steam
it from top to bottom. The combination of steam
and clothes brush will gently remove all creases.
• Use light pressure with the clothes brush and guide
the appliance from top to bottom over the garment.
You can thereby press the steam blast button 8
in short intervals.
Notice:
You can repeatedly press the steam blast button 8
until the heating-up control lamp 5glows or water
drips from the sole of the iron 0.
Then, wait until the heating-up control lamp 5extin-
guishes before activating a further blast of steam.
• Should the heating-up control lamp 5start to glow
during the process, release the steam blast button 8
and wait a few seconds until the heating-up control
lamp 5extinguishes.
Note:
Should you press the steam blast button 8whilst
the heating-up control lamp 5is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
• Leave the garment on the clothes hanger to cool
down before putting it on.
IB_KH1270_E40979_LB4 17.10.2008 11:05 Uhr Seite 5