Risk of injury from rotating parts!
NEVER reach into the mixing bowl when it is in use.
Only change accessories when the drive motor j is at standstill! After being switched off, the drive motor j continues to run for a short time. The appliance may only be used when the drive openings not being utilised are covered with drive protection lids. In cases of malfunction switch the appliance off and remove the plug from the wall socket, this will avoid an unintentional
Refilling with ingredients
•Turn the appliance off with the rotary switch g.
•Turn the rotary switch g to P and hold it firmly until the drive motor j comes to a standstill (Fig. 2).
•Remove the lid.
•Press the unlocking button f and bring the swivel arm h into operating position 5 (see chapter „Operating positions“).
•Refill with ingredients or insert the ingredients through the refill opening in the lid.
On task completion
•Turn the appliance off with the rotary switch g.
•Turn the rotary switch g to P and hold it firmly until the drive motor j comes to a standstill (Fig. 2).
•Remove the lid.
•Press the unlocking button f and bring the swivel arm h into operating position 4 (see chapter „Operating positions“).
•Remove the accessories from the drive motor j.
•Remove the mixing bowl y.
•Clean all parts (see chapter „Cleaning and care“).
Working with the food processor
Note: Ensure that on the swivel arm h neither the kneading hooks q, the whisk e nor the mixing beater w are attached.
Proceed as follows to prepare the appliance for operation with the food processor u:
•Press the unlocking button f and bring the swivel arm h into operating position 4 (see chapter „Operating positions“) (Fig. 1).
•Insert the mixing bowl y. The base of the mixing bowl y must engage in the recesses k on the appliance.
•Press the unlocking button f and bring the swivel arm h into operating position 1 (see chapter „Operating positions“).
•Remove the drive protection lid for the food processor u (Fig. 4).
•Insert the food processor u with the drive shaft a into the drive opening (The marking on the food processor u to the marking on the swivel arm h) and turn it clockwise as far as it will go (Fig. 5).
•Remove the lid with stodger d.
•Depending on the task to be performed, place the cutting s, rasping o or rubbing i disc onto the drive shaft a of the food processor. (Fig. 5).
•Place the lid with stodger d on the food processor u and latch it down (Fig. 5).
•Set the rotary switch g to the desired level.
Note: Do not press too many ingredients in the food processor u. Take note of the table in the chapter „Recommended filling quantities“.
•Insert ingredients through the loading shaft with the stodger d.
- 5 -
