Kompernass KH 1150 manual Danger, “Klick”

1Fasten the installation plate (L) to the ceiling with 2 screws and, using the pegs if necessary.

Test the bearing capacity of the screw	.
L

2 Hang the fan in the installation plate, making sure that the mount lines up properly with the notch (see Fig., circle).

Colour coding:

Green-yellow (I): PE conductor

Blue (II):	Neutral conductor
Brown (III):	Current-carrying wire (also: black)

Connect the electrical wires

Step 1: Connect the PE conductor to the lamp-wire connector (I).

Step 2: Connect the blue wire (N) (II).

Step 3: Connect the brown wire (L) (III).

1	(I)
2	(II)
3 (III)

Connect the cable plug

Connect the cable plugs of the two PE conductors of the fan with the sockets on the installation plate.

Then connect the wide cable plug of the fan to the socket on the installation plate.

4 Snap the casing (A) onto the installation plate: insert it into the two adjacent bearings and snap it into the opposing spring-loaded bearing (click!).

“KLICK”

A

3 Electrical connection.

DANGER:

The electrical connection may only be performed by a qualified electrician!

Failure to follow these instructions presents a life-threatening risk of electric shock!

￿NOTE:

Avoid touching the halogen bulbs with your fingers. Use a clean cloth or cloth gloves when inserting the bulbs.

5 Insert the halogen bulbs into the lamp holders: Place the bulbs with light pressure into the round recesses and then turn them clockwise until securely fitted.

6 Switch on the power supply.

- 5 -