Kompernass KH 1150 manual Troubleshooting, Danger

11 Troubleshooting

Problem/Fault	Possible Cause(s)	Remedy
The fastening screws cannot be screwed		Replace the screws and nuts Only use
tightly or were turned too far during instal-		screws that match the original screws;
lation.		contact the manufacturer or retailer for
		information.
The fan does not start.	Building fuse or circuit breaker defective.	Check the building fuse or circuit breaker
		and replace if necessary.
	The direction switch is positioned in the	Set the direction switch to the up or down
	middle.	position.
	Set the pull chain switch to the "OFF" setting.	Pull the pull chain once.
	Loose cable plug.	DANGER:
		Disconnect the fan from the mains network
		before checking the cable plug. Check the
		cable plug.
	Fan defective.	Have the ventilator checked by specialists
		or send it to Customer Services (Address -
		see Chapter "Warranty and Service").
Fan runs loudly or sways significantly.	Blade mounts not firmly connected.	Check the screw connection of the blade
		mounts.
	Blade damaged.	Check the blades, replace if necessary.
	Blade not balanced out.	Change the positionings of the blades
		amongst themselves.
	Loosen blade attachment(s).	Check the blade attachments.
	Fan is not hung correctly.	DANGER:
		Disconnect the fan from the mains network
		before checking whether it is hung correctly.
		Check the fastening of the installation plate
		and extension rod, and correct any improper
		fastening.
Light does not function.	Bulb defective.	Check the halogen bulbs and replace
		defective bulbs.
	Loose cable plug.
		DANGER:
		Disconnect the fan from the mains network
		before checking the cable plug. Check the
		cable plug.

Do not perform any modifications or repairs on the product!

Safety-relevant parts may only be repaired by a specialist.

- 7 -