To programme a Macro
For Macro programming proceed as follows:
1.Hold down the S button r for a little longer than 3 sec- onds. The notice "CODE SETUP" appears.
2.With the or button t select "MACRO SETUP" and confirm with the OK button k. In the display "MACRO SETUP 1" appears.
3.With the or button t select the memory slot to be programmed (MACRO SETUP 1 - 4) and confirm with the
OK button k.
4.In the LCD display q "MACRO STEP" appears. Now press, one after the other, the desired buttons (max. 16). The sequence should begin with a device button e.
5.When the maximum number of button commands is reached the LCD display q shows "FULL".
6.Save the entry with the S button r. In the LCD display q "MACRO SETUP" appears.
7.If, with the selection of the Macros to be programmed (step 3), you select a memory slot that is already occupied the existing Macro will be overwritten.
8.Repeat the process from step 3 to create further Macros.
9.With the EXIT button y you move a level upwards in the menu except during the entry of the button commands.
Tips:
1.A maximum of 16 button commands can be saved in a Macro. After entering the 16 button commands the Mac- ro is automatically saved and in the LCD display q "FULL" appears.
2.To exit the mode without saving allow approx. 15 sec- onds to pass without an entry.
3.In the mode "MACRO STEP" you can only return to the previous status with the S button r.
Example: You want to save a command chain in a Macro. We begin in the mode "MACRO STEP".
Desired command chain: Switch on TV => switch to the AV input => switch on DVD and playback.
In the mode "MACRO STEP", for this you enter the following
button commands: 
=> 
=> 
=> 
=> 
=>
Execute a Macro
To execute a
1.Press the MACRO button i.
2.With the corresponding number button o you access the desired Macro 
".
- 18 -
